]]>
]]>
]]>
]]>
I've been doing the guide for a while and when i came at the light sensor part i notesed that my ringo just printed strange sighs like: äėê'+êè I searched the internet and found out you need to open the serial port with an specific bits per second. The standard amound is 9600 bps otherwise you need to change it in your serialmonitor
Here is the code to fix it:
setup() {
// open the serial port at 9600 bps:
Serial.begin(9600);
}
Best regards Quinten
Sorry for my bad english. I hope you understood it
Statistics: Posted by Quinten1333 — Thu Sep 10, 2015 9:08 pm
]]>
Thanks for the feedback. Hooking up the cable to only the top row of pins or hooking it up reversed won't cause any long term problems so no worries there.
-Kevin
Statistics: Posted by Kevin — Mon Aug 10, 2015 6:58 pm
]]>
1. Despite the warning, I managed to connect the ribbon to only the top layer of pins on the Ringo. It is a tight fit.
2. I carefully read about the red stripe and how to connect the the Ringo and the programer. Alas I managed to connect the wrong way! This happened while I was having other problems. Fortunately neither 1. nor 2. affected the Ringo.
3. I had lots of problems getting a proper port. This could have been due to a poor or marginal cable.
4. At first neither Arduino 1.0.6 nor the latest 1.6.5 seemed to work. However, after loading fresh copies and a better cable, I found that both version work.
Statistics: Posted by talasinski — Mon Aug 10, 2015 6:11 pm
]]>
We've just posted up a revised version of the Ringo guide and some code. It's 11pm now and I've been at the shop since about 5am working on this, so the guide probably still has a few errors in it. The words were starting to walk around the page on their own - I'm taking that as a clue that it's time for rest.
If you're just getting started, please FIRST visit http://www.plumgeek.com and follow the 3 steps posted to install the driver for Ringo's programmer, the Arduino IDE software, and the Ringo libraries. Once those items are taken care of, you can start playing.
Get the Ringo guide here: (and keep watching this page as we update it this week - still need to add some new sections and complete others)
http://www.plumgeek.com/ringo-guide.html
On that page you can also get the companion code that goes along with the guide, and most important.... get the latest version of the "Base Sketch". Use the Base_Sketch as a basis for writing your own code. It's already got all the most up to date back-end functions in the tabs. We're really happy with the back-end functions. Dustin was able to really clean them up nice over the past few days.
Finally.... the "10 example behaviors" should be together mid this week. These will be mostly behaviors from the Kickstarter video. Just need to port them over to work with the most recent version of back-end functions.
Within a week or so we should have the libraries and examples all organized in a neat folder that you can drop right into your Arduino folder. We're putting it out as we have it so everyone can start doing something right away as their Ringos arrive.
G'night!
-Kevin
Statistics: Posted by Kevin — Sun Aug 09, 2015 6:11 am
]]>