Plum Geek Forum

Hi,

Charged switched off,charging Led did go off. Have always charged it switched on before thinking Arduino needed to be running to track battery charge.

Thanks for the response and help.

Hi,

Should the Charge LED switch-off when the battery is fully charged ? Mine does not stays lit when ever I connect to USB.

Hi Kevin,

I can confirm I do see the Com led blink.

I have tried altering the i2c delay to various values on both volts.py & rangefinder.py but the outcome is the same.
Sorry not able to help with items 3&4

Regards

Nick

Hi Kevin,

I can confirm I get same result running the rangefinder.py

Rangefinder: Wrong register replied
0
Wrong register replied
0
Wrong register replied
0

Hi,

After some help. When I run the volts.py provided in the democode directory, it gives the following output

Battery Voltage: Wrong register replied
0
Wrong register replied
0
Wrong register replied
0

Can anyone suggest why this might be ?

Thanks in advance for any help provided

Hi, Just finished following the instructions to setup the Pi, I came across two issues. 1) Installing the NeoPixel Code failed, reported pyhton.h file missing. After a bit of investigation on the Web I installed Python Dev then re ran the install of rpi_ws281x this the installed clean. I used follow...

Thank you that worked

Hi, As I've been researching my Upload problem I have seen a number of references to an LED to indicate the Bootloader is good. I see no such LED on the Spirit Rover does anyone know if this LED is on the Spirit ? The only LED's I see active are PWR & COM when unit is on and amber charge LED whe...

Hi, Thanks for your response I have tried both, i.e Not pressing PWR button before uploading and pressing PWR button then uploading. Outcome the same in both cases. I have Board Selected as Auduino/Genuino Uno within the IDE application, but when I use the 'Get Board Info' it returns 'Unknown Board'...

Hi, I have my Spirit built and it is happily running the Demo code :D Today I made my first attempt to right very simple code using the Base sketch provided, this complies ok but fails to upload. I have checked the basics, such as checking I can communicate to the Spirit this appears to work via Com...