Wink Issue.
Posted: Thu Jan 21, 2016 4:39 pm
Hi,
i received my wink recently. i am on macbook air, mac 10.11.2 and am using the latest arduino IDE 1.6.7 and the latest FTDI 2.3 drivers.
The issue i am facing is:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
this goes on for 10 attempts and then it stops. the port i see is "/dev/cu.usbserial-DA01HH35"
I've tried following things to make it work:
1. switching out usb cables.
2. reinstalling all the drivers.
I am not sure if the programmer is faulty or its a driver issue. the charging led turns on on wink when connected, and while it attempts to upload the sketch, the led for RX blinks every time a 'new attempt' is made. i couldnt get it to work with answers in previous posts, can anyone please help????
Thanks.
Kushagr
i received my wink recently. i am on macbook air, mac 10.11.2 and am using the latest arduino IDE 1.6.7 and the latest FTDI 2.3 drivers.
The issue i am facing is:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
this goes on for 10 attempts and then it stops. the port i see is "/dev/cu.usbserial-DA01HH35"
I've tried following things to make it work:
1. switching out usb cables.
2. reinstalling all the drivers.
I am not sure if the programmer is faulty or its a driver issue. the charging led turns on on wink when connected, and while it attempts to upload the sketch, the led for RX blinks every time a 'new attempt' is made. i couldnt get it to work with answers in previous posts, can anyone please help????
Thanks.
Kushagr