Plum Geek Forum

Hi,

I am working with a Mac running El Capitan. I have installed the latest Mac FTDI driver (v2.3), Arduino (v1.6.7) and Ringo library (Rev01-01).

Steps taken
1. Power on my Wink, the 2 eyes are lit up with blue lights
2. Start Arduino, connect the cable and ensured the serial port is connected.
3. Open the Ringo_PreLoaded_Behaviors_Rev06_01 files and click upload
4. Compiling sketch, uploading and finally done uploading appears, with no error messages
5. Wink's eyes are still blue and nothing happens when pressing any buttons on the Plum Geek remote. (batteries on remote are changed too)

Please advise

MadLing

Yes, Wayne. You are right. I used the Ringo libraries instead of Wink. The website was slightly confusing as it brought me to the Ringo page when downloading the initial setup. Anyway, things are good now. Thanks again for your pointers!

MadLing