Note: zero trim values in your copy of the Base Sketch

The more technical aspects of Spirit, and carry-over discussion from Kickstarter updates.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
gpvillamil
Posts: 75
Joined: Fri Jan 26, 2018 5:03 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Note: zero trim values in your copy of the Base Sketch

Postby gpvillamil » Sun Feb 04, 2018 11:13 pm

Just a quick note, hopefully it will avoid headaches.

If you have set the servo trims by modifying the trim values in the Hardware tab, make sure to then zero the trim values in your own copy of the Base Sketch from then on, otherwise you'll be using the trim values in that sketch! I think by default they are set to tilt: 25, pan: 0, grip: -1 which may not be the right ones for your rover.

[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Who is online

Users browsing this forum: No registered users and 22 guests