[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Plum Geek Forum • Note: zero trim values in your copy of the Base Sketch
Page 1 of 1

Note: zero trim values in your copy of the Base Sketch

Posted: Sun Feb 04, 2018 11:13 pm
by gpvillamil
Just a quick note, hopefully it will avoid headaches.

If you have set the servo trims by modifying the trim values in the Hardware tab, make sure to then zero the trim values in your own copy of the Base Sketch from then on, otherwise you'll be using the trim values in that sketch! I think by default they are set to tilt: 25, pan: 0, grip: -1 which may not be the right ones for your rover.