Base sketch won't upload
Posted: Sat Feb 10, 2018 6:35 pm
Hi,
I idownloaded CDM21216_Setup.exe from the site and installed the usb driver.
Halas, when I try to upload the Spirit_BaseSketch_PiControl_Rev01.ino, I get the notorious averdude stk500_recv() error:
----------------------------------------------------------------------------------------------------------------------
Arduino: 1.6.9 (Windows 10), Board:"Arduino/Genuino Uno"
De schets gebruikt 7.714 bytes (23%) programma-opslagruimte. Maximum is 32.256 bytes.
Globale variabelen gebruiken 469 bytes (22%) van het dynamisch geheugen. Resteren 1.579 bytes voor lokale variabelen. Maximum is 2.048 bytes.
avrdude: Version 6.0.1, compiled on Apr 15 2015 at 19:59:58
Using Port : COM4
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xc3
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xc3
avrdude done. Thank you.
-----------------------------------------------------------------------------------------------------------------------------
It’s the first time since assembly that I tried to upload a sketch (I was waiting for the PI-interface).
As mentioned in other posts and the Ringo & Wink pages, I surely tried the Pro/pro-mini versions 8Mhz and 16 Mhz and a lot of the other Arduino configurations, but all with the same result. And of course several re-installs of the usb driver.
‘ Years ago’ I could solve this issue by using another Arduino as programmer. I don’t know how I could manage this on the Spirit board (just a USB connector).
Does anyone know a workaround?
I idownloaded CDM21216_Setup.exe from the site and installed the usb driver.
Halas, when I try to upload the Spirit_BaseSketch_PiControl_Rev01.ino, I get the notorious averdude stk500_recv() error:
----------------------------------------------------------------------------------------------------------------------
Arduino: 1.6.9 (Windows 10), Board:"Arduino/Genuino Uno"
De schets gebruikt 7.714 bytes (23%) programma-opslagruimte. Maximum is 32.256 bytes.
Globale variabelen gebruiken 469 bytes (22%) van het dynamisch geheugen. Resteren 1.579 bytes voor lokale variabelen. Maximum is 2.048 bytes.
avrdude: Version 6.0.1, compiled on Apr 15 2015 at 19:59:58
Using Port : COM4
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xc3
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xc3
avrdude done. Thank you.
-----------------------------------------------------------------------------------------------------------------------------
It’s the first time since assembly that I tried to upload a sketch (I was waiting for the PI-interface).
As mentioned in other posts and the Ringo & Wink pages, I surely tried the Pro/pro-mini versions 8Mhz and 16 Mhz and a lot of the other Arduino configurations, but all with the same result. And of course several re-installs of the usb driver.
‘ Years ago’ I could solve this issue by using another Arduino as programmer. I don’t know how I could manage this on the Spirit board (just a USB connector).
Does anyone know a workaround?