Plum Geek Forum

Would it be possible to get some documentation on that big connector between the Raspberry Pi and the main board? (Also the XBee, Bluetooth, WiFi connectors - but the big one is the GPIO.)

I've been going through the Python code but I can't find any clear definitions.

As far as I can tell, the spidev.py default config doesn't seem to match the pin numbering in the Arduino sketch. However, it clearly works.

My goal is to see if I can set up programming of the Arduino from the Pi as described here:

Kevin, this would be a great help!

Kevin,

The community really needs these specs.

If it will help I can take a schematic and create a doc from it detailing the pinout, etc..

Marc

Just posted the schematic. It's a sticky at top of the discussion.

Great!!

I will look at this and create some docs to detail the interface.

Will post a link to them when I am done. Will put them into one of the repos I have created on github or maybe make a new one for docs??