Plum Geek Forum

after playing for a while this error poped up

Arduino: 1.6.4 (Windows 8.1), Board:"Arduino Fio"

FunStuff.ino: In function 'void sensorcheck()':
FunStuff:29: error: a function-definition is not allowed here before '{' token
FunStuff:45: error: a function-definition is not allowed here before '{' token
FunStuff:55: error: a function-definition is not allowed here before '{' token
RingoHardware:948: error: expected '}' at end of input
a function-definition is not allowed here before '{' token

i've tried to delte the file funstuff but then it will just say
Arduino: 1.6.4 (Windows 8.1), Board:"Arduino Fio"

In file included from Navigation.ino:26:0:
A LOT OF LOCATION'S IN MY ARDUINO INSTALLATION FOLDER

Navigation:41: error: a function-definition is not allowed here before '{' token
Navigation:45: error: a function-definition is not allowed here before '{' token
RingoHardware:948: error: expected '}' at end of input
a function-definition is not allowed here before '{' token

so that doesn't work

I made about 5 sketches now and they all look (quite) the same(line follower).
also what i just edited in my sketch was the line detecting part wich is in all my sketches

hope someone knows the problem
sorry for bad english

Quinten,

You want to leave all the files in place. It sounds as if there's a syntax error someplace. I don't think Arduino forces you to "define" a function before using it (this is a rule in C but I think Arduino overlooks this).

Check that you didn't miss a semicolon in your new function, and also make sure you didn't forget a closing curly brace }

If all else fails, open a clean copy of the Base Sketch, make your changes, then post it here so we can see it.

Good luck.

I am so stupid

your right i forgot to use closing brackets in my new function

but how does that affect other tabs?


THANKS FOR RESPONDING SO FAST

okey thanks for your help