Search found 3 matches

by giuseppe
Fri Nov 13, 2015 5:49 am
Forum: Ringo Basics
Topic: motor design
Replies: 5
Views: 1024

Re: motor design

i would use a nano-quadcopter propeller as the actual attachment, which is designed to pop on the end of these exact motors. then all that's needed is to 3d print a cylinder that the ends of the propeller clip into the inside of, and we've got a wheel with treads if need be -- It's not high on my to...
by giuseppe
Sun Nov 08, 2015 4:06 am
Forum: Ringo Basics
Topic: motor design
Replies: 5
Views: 1024

Re: motor design

How much slack is there in the wire from board to motor? I haven't got my Ringo yet but I'm just wondering about the potential for a 3d-printed add-on which is a little clip clipped onto the ringo body, allowing me to have the motors flat for a standard wheeled setup too for surfaces that arent so u...
by giuseppe
Sun Nov 08, 2015 3:49 am
Forum: Ringo Basics
Topic: It's alliiiiveeeee
Replies: 2
Views: 862

It's alliiiiveeeee

Hello all, this is my first post here, and my first step into programming robots! I thought I would make a thread where I keep all of my posts in chronological order, a journal of my Ringo adventure. It's not actually alive yet, as I ordered it yesterday and I imagine it will probably be dispatched ...